Plasmaleikkuri Tomahawk 30K (with build-in air compressor)

Plasma cutting - anywhere, anytime. The Tomahawk® 30K plasma cutter is ready for fast and accurate cutting - it works both with a built-in compressor and when connected to a compressed air line. Forget the angle grinder, just pick up the torch and cut in seconds. Maximum cutting power 16mm (recommended up to 12mm). Functions: • Ultimate portability – the internal air compressor enables operation in environments where external compressed air is not available. • Continuous output control – suitable arc for different material thicknesses. • "Touch Start" starting system - reliable plasma arc starting without high frequency. • Rapid Arc Restrike - rapid cutting of gaps. • Pressure regulator on the front panel - makes it easy to set the air flow rate without starting the plasma arc. • Dip and grid modes (adjustable grid time) • New design of electrodes and nozzles save money in the long run. • Additional safety – our consumables installation system detects correct installation of consumables and torch. • Select a suitable generator to power the Tomahawk® in remote locations. Technical specifications: Supply voltage 230V, 1-phase, Current strength 15-30A. Protection (slow) 16A. 20A when starting the arc. Duty cycle 30A@60%, 25A@100%. Weight 18.5 kg. Dimensions 385x215x480mm. Air requirement 125l/min +/- 10% @ 5.0-6.0bar. The set includes: Built-in air compressor, power cable, 4m manual torch LC30, ground clamp and cable, consumable parts for the torch, built-in moisture separator. 2-year warranty.